Gutter Brackets
Gutter brackets carry the weight of a full gutter and set the fall along a run, so water reaches the outlet instead of standing. Fascia, top-hung and union types match each profile from 112mm to 170mm, letting plastic gutter brackets drop into an existing line during a repair. Fits ogee guttering.
Free delivery on orders over £150 inc VAT.
23 UK Branches
In Stock
In Stock
In Stock
In Stock
Aquaflow 112mm Half Round Cast Iron Effect Gutter Fascia Bracket
£2.51Inc. VAT
View Product
Available
In Stock
In Stock
In Stock
In Stock
Aquaflow 114mm Krown Ogee Cast Iron Effect Gutter Union Bracket
£12.62Inc. VAT
View Product
Available
Choosing Gutter Brackets
Frequently Asked Questions
Fascia brackets are normally fixed at 800mm to 1000mm centres, closer where snow load is likely, with a bracket within 150mm of every union, angle and outlet. Set a fall of roughly 1:600 towards the outlet, about 3mm per metre, so water runs off rather than standing in the bottom of the gutter.
Through into the rafter ends with polytop nails or stainless screws, two per rafter, at the top and bottom of the board so it cannot rotate under the weight of a full gutter. Fix into sound timber — if the rafter ends are soft they need cutting back and a new timber before the board goes on.
Not reliably. Profiles that look alike often differ by a few millimetres across the seal, so a union from one system may not grip, or may leak, on another. Match the profile and size already on the building. If a run is being replaced piecemeal, bring an offcut or a photo of the union before ordering.
Look at the front edge from the ground. A plain curve is half round, a flat face with a square shoulder is square, and a moulded, shaped front is ogee. Then measure across the top of the gutter: 112mm and 114mm are the common domestic sizes, with 125mm, 130mm and 170mm on deeper and commercial systems.
The joints and brackets are straightforward — the difficulty is working at height. A single-storey run off a low extension or garage is reasonable from a stable ladder or a tower. A two-storey elevation, or anything over a conservatory roof or a stairwell, is a job for a fitter with proper access.