Klassic Ogee Guttering
Klassic ogee guttering is the 130mm Aquaflow profile, deeper than a standard domestic gutter and shaped with a moulded front face that suits a Victorian or Edwardian elevation. Runs come in 4m lengths with 66mm square downpipe, angles, outlets and stop ends. Hangs on gutter brackets.
Free delivery on orders over £150 inc VAT.
22 UK Branches
In Stock
In Stock
Aquaflow Left Hand Adaptor 130mm Klassic Ogee to 112mm Half Round Gutter
£27.19Inc. VAT
View Product
Available
In Stock
Aquaflow Left Hand Adaptor 130mm Klassic Ogee to 114mm Square Gutter
£27.19Inc. VAT
View Product
Available
In Stock
Aquaflow Right Hand Adaptor 130mm Klassic Ogee to 112mm Half Round Gutter
£27.19Inc. VAT
View Product
Available
In Stock
Aquaflow Right Hand Adaptor 130mm Klassic Ogee to 114mm Square Gutter
£27.19Inc. VAT
View Product
Available
Choosing Klassic Ogee Guttering
Frequently Asked Questions
Look at the front edge from the ground. A plain curve is half round, a flat face with a square shoulder is square, and a moulded, shaped front is ogee. Then measure across the top of the gutter: 112mm and 114mm are the common domestic sizes, with 125mm, 130mm and 170mm on deeper and commercial systems.
Not reliably. Profiles that look alike often differ by a few millimetres across the seal, so a union from one system may not grip, or may leak, on another. Match the profile and size already on the building. If a run is being replaced piecemeal, bring an offcut or a photo of the union before ordering.
Fascia brackets are normally fixed at 800mm to 1000mm centres, closer where snow load is likely, with a bracket within 150mm of every union, angle and outlet. Set a fall of roughly 1:600 towards the outlet, about 3mm per metre, so water runs off rather than standing in the bottom of the gutter.
Plastic moves with temperature — a long run can grow several millimetres between a frosty morning and a hot afternoon. Pushing every joint fully home leaves nowhere for that to go, so the run bows or pops a seal. Each union carries an insertion mark; stop at it rather than at the back of the socket.
Most house roofs are fine on 112mm half round with 68mm downpipe. Step up to a deep flow or ogee profile where the roof area is large, the pitch is steep, or one run serves a long elevation. Warehouse, farm and flatted buildings need the 170mm and 200mm commercial sections.