Krown Ogee Guttering
Krown ogee guttering is the deeper 125mm section in the Krown range, taking more water than a standard domestic profile while keeping the moulded front face. Deep flow ogee guttering runs come in 4m lengths with 66mm square and 68mm round downpipe. Hangs on gutter brackets.
Free delivery on orders over £150 inc VAT.
23 UK Branches
Special offer
24tubes
Soudal LMN Silicone Sealant, Box of 24
White or Clear, 300ml tubes
£86.11
/ box
Inc. VAT
Just £3.59 a tube
Shop the Box Deal
Whole boxes of 24 only
In Stock
Aquaflow 68mm Square Cast Iron Effect Downpipe Offset Bend 92.5°
£23.81Inc. VAT
View Product
Available
Special offer
24tubes
Soudal LMN Silicone Sealant, Box of 24
White or Clear, 300ml tubes
£86.11
/ box
Inc. VAT
Just £3.59 a tube
Shop the Box Deal
Whole boxes of 24 only
Choosing Krown Ogee Guttering
Frequently Asked Questions
Look at the front edge from the ground. A plain curve is half round, a flat face with a square shoulder is square, and a moulded, shaped front is ogee. Then measure across the top of the gutter: 112mm and 114mm are the common domestic sizes, with 125mm, 130mm and 170mm on deeper and commercial systems.
Most house roofs are fine on 112mm half round with 68mm downpipe. Step up to a deep flow or ogee profile where the roof area is large, the pitch is steep, or one run serves a long elevation. Warehouse, farm and flatted buildings need the 170mm and 200mm commercial sections.
Not reliably. Profiles that look alike often differ by a few millimetres across the seal, so a union from one system may not grip, or may leak, on another. Match the profile and size already on the building. If a run is being replaced piecemeal, bring an offcut or a photo of the union before ordering.
Fascia brackets are normally fixed at 800mm to 1000mm centres, closer where snow load is likely, with a bracket within 150mm of every union, angle and outlet. Set a fall of roughly 1:600 towards the outlet, about 3mm per metre, so water runs off rather than standing in the bottom of the gutter.
Plastic moves with temperature — a long run can grow several millimetres between a frosty morning and a hot afternoon. Pushing every joint fully home leaves nowhere for that to go, so the run bows or pops a seal. Each union carries an insertion mark; stop at it rather than at the back of the socket.