Kitchen Wall Panels

Kitchen wall panels give a wipe-clean splashback behind a hob, sink or worktop with no grout lines to scrub. PVC wall panels fit over existing tiles or plaster in 250mm, 400mm and 1000mm widths, in marble, stone and white finishes. The same boards line a wet room as bathroom wall panels.

Free delivery on orders over £150 inc VAT. 22 UK Branches

Showing 127 Results

In Stock
White Gloss Wall Panel 250mm x 2.6m x 5mm (Pack of 4)White Gloss Wall Panel 250mm x 2.6m x 5mm (Pack of 4) - installed
White Gloss Wall Panel 250mm x 2.6m x 5mm (Pack of 4)Length: 2.6m
£27.96/ packInc. VAT
£6.98 / panel View Product
Available
In Stock
White Sparkle Wall Panel 1000mm x 2.4m x 10mmWhite Sparkle Wall Panel 1000mm x 2.4m x 10mm - installed
White Sparkle Wall Panel 1000mm x 2.4m x 10mmLength: 2.4m
£43.00Inc. VAT
View Product
Available
In Stock
White Sparkle Wall Panel | 250mm x 2.6m x 8mm (Pack of 4)White Sparkle Wall Panel | 250mm x 2.6m x 8mm (Pack of 4) - installed
White Sparkle Wall Panel | 250mm x 2.6m x 8mm (Pack of 4)Length: 2.6m
£35.96/ packInc. VAT
£8.99 / panel View Product
Available
In Stock
Zeera Green Wall Panel 1000mm x 2.4m x 10mmZeera Green Wall Panel 1000mm x 2.4m x 10mm - installed
Zeera Green Wall Panel 1000mm x 2.4m x 10mmLength: 1m
£58.00Inc. VAT
View Product
Available
In Stock
Pasadena Part 1  | 10mm X 1m X 2.4mPasadena Part 1  | 10mm X 1m X 2.4m - installed
Pasadena Part 1 | 10mm X 1m X 2.4mLength: 1m
£43.00Inc. VAT
View Product
Available
In Stock
Pasadena Part 2 | 10mm X 1m X 2.4mPasadena Part 2 | 10mm X 1m X 2.4m - installed
Pasadena Part 2 | 10mm X 1m X 2.4mLength: 1m
£43.00Inc. VAT
View Product
Available

Choosing Kitchen Wall Panels

Behind the hob

Electric and induction hobs are fine. With gas, keep 200mm between the flame and the board, or fit glass or steel in that zone and panel either side of it. Check the hob manufacturer's clearance figures, as some ask for more than that.

Splashback or full wall

A splashback run between worktop and wall units usually takes one or two 1m boards cut to height, which is the quickest job and needs only edge trims. Panelling the full wall makes more sense in a utility, or where the existing wall surface is in poor condition.

Cutting in

Sockets and switches are marked on the face, drilled at the corners and cut out with a jigsaw. Cut tight, as the faceplate hides a few millimetres. Isolate the circuit first. Wipe-clean is the point here: no grout lines means no grease trap along the worktop.

Frequently Asked Questions